sticky note holder and gift box

Today I have a tutorial over on the Scor-Pal blog.  The DT is updating some of the older tutorials and I recently revised the Sticky Note Holder and Gift Box tutorial with a few alterations in the measurements and directions.

Sticky Note Holder & Gift Box

By Diane Zechman

Adapted from tutorial by Bridgett Owens

Supplies:

Scor-Pal, Scor-Tape

Paper cutter

Scissors

Sticky Note pad

papers, ribbon, etc. to embellish

stamps and ink, if desired (Sweet ‘n Sassy- Winter Girls used here)

Note Holder:

2 pieces of 3 ½” x 3 ½” chipboard

1 piece of 3 ¼” x 6 ¾” cardstock or heavy patterned paper

2 pieces of 4 ½” x 4 ½” patterned paper

Gift Box:

1 piece of 4 ¾” x 10 ¼” cardstock

Sticky Note Holder

Step 1: Align the 3 ¼” x 6 ¾” cardstock along the left fence and score the 6 ¾” side @ 3 ¼” and 3 ½”.  Fold and crease scored lines.  Set aside.

Step 2: Apply Scor-Tape to one side of each of the chipboard pieces.  Center each chipboard square onto the back side of the 4 ½” patterned paper.  Miter the corners and secure the sides down with additional Scor-Tape. 


Step 3: Apply Scor-Tape to one side of your cardstock up to the first score line and center it onto one chipboard square. Repeat this process for the other chipboard cover.

Step 4: Adhere sticky note pad to the inside and decorate as desired.

Gift Box

Step 5: Align cardstock along the left fence and score the 10 ¼” side @ 1/2” and 9”.

Step 6: Slide the cardstock over so the left side is at the 1/8” mark.  Score @ 4 ¼” and 5 ½”.

Step 7: Turn the cardstock 90 degrees and score @ 3”. 

Step 8: Using scissors, cut the vertical score lines up to the horizontal score line.  Remove the small rectangular section at the bottom left.  Then trim the 2 largest flaps to 1 ¼” wide.  This will create the box bottom.  You will now have four flaps.

Step 9: Fold and crease all scored lines.  Adhere patterned paper layers to the front side, if desired.

Step 10: Turn the paper over.  Fold both sides in, adhering together  with Scor-Tape to form the box.

Step 11: Fold bottom flaps in one at a time, applying Scor-Tape to adhere the flaps shut.

Step 12:  Decorate as desired.  The gift box will hold 1 or 2 Sticky Note Holders.

One response to “sticky note holder and gift box

  1. Super cute project. It would make wonderful gifts for teachers! Thanks for the tutorial. I’m going to give it try :-)
    Lena
    xxx
    Lena’s Creations

Leave a Reply

Your email address will not be published.